A Review of Assembly Process of Retaining Wall LED Backlight and LCD Screen

[vc_row][vc_column width=”1/6″][/vc_column][vc_column width=”2/3″][vc_raw_html]JTNDaWZyYW1lJTIwd2lkdGglM0QlMjI5NjAlMjIlMjBoZWlnaHQlM0QlMjI1NDAlMjIlMjBzcmMlM0QlMjJodHRwcyUzQSUyRiUyRnd3dy55b3V0dWJlLmNvbSUyRmVtYmVkJTJGMk5SeHdsMk5CY2MlMjIlMjB0aXRsZSUzRCUyMllvdVR1YmUlMjB2aWRlbyUyMHBsYXllciUyMiUyMGZyYW1lYm9yZGVyJTNEJTIyMCUyMiUyMGFsbG93JTNEJTIyYWNjZWxlcm9tZXRlciUzQiUyMGF1dG9wbGF5JTNCJTIwY2xpcGJvYXJkLXdyaXRlJTNCJTIwZW5jcnlwdGVkLW1lZGlhJTNCJTIwZ3lyb3Njb3BlJTNCJTIwcGljdHVyZS1pbi1waWN0dXJlJTIyJTIwYWxsb3dmdWxsc2NyZWVuJTNFJTNDJTJGaWZyYW1lJTNF[/vc_raw_html][vc_column_text]Welcome to DISPLAYBLY.COM.

Today we are going to introduce an assembly process of retaining wall LED backlight and LCD screen.

First, put the reflection sheet on a special clamp as the first layer, the light guide plate as the second layer and diffusion sheet as the third layer.

Second, put the light-blocking film on the edges of the light guide plate by hand.

Third, glue the LED (pause) and install it into the light guide plate.

Fourth, remove the protection film from the bottom of the LCD screen and the protection film from the top of the LED backlight.  And press the LCD screen into the walls of the LED backlight by hand.

Fifth, quality test. Check if there is any fault.

Sixth, labeling, and packing.

Thank you for watching and contact us if you have any questions.[/vc_column_text][/vc_column][vc_column width=”1/6″][/vc_column][/vc_row]

Published
Categorized as Vlog

Leave a comment

Your email address will not be published.